24
| P a g e © Adam Equipment Company 2010
10.5.2 SETTING UP WHILE PARTS COUNTING OR % WEIGHING
During parts counting and percent weighing the limits are set in the same way as
above. The limits are displayed in pcs or %.
See Section 10.4 for the description of parts counting and Section 10.7 for percent
weighing.
NOTE:
1. The weight must be greater than 20 scale divisions for the check-
weighing to operate.
2. To disable the check weighing function, enter zero into both the limits as
described above. When the current limits are shown, press [CE] to clear
the settings, then press [Tare] to store the zero values.
10.6. LIMITS STORING AND RECALLING
The scale can store up to 10 sets of high and low limits in memory along with the
weighing units in use (including pcs for parts counting and % for percent weighing)
as well as settings for the beeper and bar graph.
During Check weighing the current limits can be stored or previously stored units
can be recalled.
To Next Page
Loading...
Need help?
General
