22
| P a g e © Adam Equipment Company 2010
10.5. CHECK-WEIGHING
Check-weighing is a procedure to display an indicator or sound an alarm when
the weight on the platform meets or exceeds the values stored in the
memory. The memory holds values for a high limit and a low limit. Either or
both the limits can be set by the user.
NOTE:
1. The alarm and the LED bargraph can each be set to OFF (See section 13.1).
The LCD display will indicate whenever the weight is within or exceeds the
limits by showing ‘OK’, ‘HI’ or ‘LO’.
2. The limits can be locked by the manager. A Limit Password must be used to
change the limits or recall other limits from memory.
3. If Limit Password is enabled then enter the password which will allow you
to change the limits or the operation of the beeper or bargraph.
Mass on the platform is above the high limit
Mass is between the limits
Mass is below the low limit
To Next Page
Loading...
Need help?
General
