41
| P a g e © Adam Equipment Company 2010
13. PARAMETER SETTINGS
Pressing the [Func] key allows the user to access the parameters for customising the
scale. The parameters are split into 3 groups-
1. Check weighing parameters,
2. RS-232 parameters and
3. Scale parameters
4. Percent and Animal Weighing Functions
• When [Func] is pressed, display will first show “FUnC 1” for Check weighing
parameters.
• Enter [2] for RS-232 parameters or [3] for Scale parameters or [4] for percent
weighing and animal weighing, or press the [Func] key to advance through
the groups “FUnC 1”, “FUnC 2” , “FUnC 3” and “FUnC 4”. Press [Tare] to enter the
desired group of parameters.
• Press [Zero] to return to the group “FUnC 1”. If you press [Zero] again, the
scale will exit the User Parameter section and return to normal weighing.
13.1. CHECK WEIGHING PARAMETERS
• Shortcut to enter this group is to press and hold the [Unit] key for 4 seconds.
The display will go directly to “FUnC 1”.
• Press [Tare] to enter the group.
• Press [Func] to scroll through the parameters and press [Tare] to enter a
parameter setting.
To Next Page
Loading...
Need help?
General
