25
| P a g e © Adam Equipment Company 2010
Press the [
Lim] key. If you are already in
the check weighing mode the display will ask
if you wish to store the current limits by
showing “StOrE” or recall another set of limits
by showing “rECALL”. The [
Lim] key can be
used to toggle between “StOrE” and “rECALL”.
If you want to store the limits, when “StOrE”
is displayed press the [Tare] key. The display
shows “St ”. Enter a number corresponding
to the desired memory location (0 to 9). “St
X” will be displayed for 2 seconds indicating
the location X where the current limits,
weighing units and settings for the beeper
and bar graph are stored. The scale will
continue to work with the current settings as
active.
If you wish to recall any of the pre-stored
limits, press [Tare] when “rECALL” is
displayed. The display shows “rEC ”. Enter the
number corresponding to the desired
memory location (0 to 9) to be recalled. “rEC
X” will be displayed for 2 seconds indicating
the values stored in the location “X” is being
recalled. The scale will change to the
recalled limits, weighing units and settings
for the beeper and bar graph.
To Next Page
Loading...
Need help?
General
