RM244V & CS4 User Manual
FM Tuner
The FM tuner function operates in the same way as a standard FM radio and benefits from the
connection of an FM antenna to the rear panel ‘F’ type connector (26).
If no channels are tuned in, press the Play/Pause button () to begin auto tuning, which scans
available stations and stores them as channels within the FM tuner.
Pressing Play/Pause again will abort the auto-tuning.
To step through pre-set stations, press the Previous or Next (, ) buttons.
Holding the Previous track or Next track buttons will adjust the output volume of the player.
Bluetooth
The Bluetooth function allows connection of a smart phone or tablet to the media player section for
playback of stored files or streamed digital audio. In order to enable this function, it will be necessary
to pair the sending device to the receiver as follows.
1. Open the Bluetooth settings menu on the smart phone or tablet (or other sending device)
2. Scan for Bluetooth devices and look for “adastra” in the list of available devices
(ensure that the RM244V is powered on and within reception range)
3. Select “adastra” and the sending device should confirm that it is connected as an audio device
4. If more than one “adastra” Bluetooth devices are present, it may be necessary to try each one
In this case and if available, rename the Bluetooth ID on the paired device to aid identification
5. Play audio from the sending device, ensuring that volume controls are not turned down/muted
6. Turn up the MEDIA volume control on the amplifier to the required level
Track navigation can be controlled from the paired device or from the front panel of the RM244V.
Previous, Next and Play/pause buttons (, , ) will operate in Bluetooth as remote playback
controls.
Holding down the Previous or Next buttons will also adjust the volume of the player.
Bluetooth range is between 5m and 10m. It is necessary to stay within this distance of the RM244V
in order to maintain the Bluetooth connection.
To Next Page
Loading...
