13
OPERATION GUIDE
1.3 Program Scenes.
1. Activate Record Enable, as described in the Record
Enable section.
2. Select the 1-48 Single mode by tapping the the Mode
Select button. This will give you control of all 48 chan-
nels as you program. Be sure that Master A & B are
both set at maximum.(Master A is at its maximum in the
fully up position, while Master B is at its maximum in
the fully down position.)
3. Create a desired scene using Channel Sliders 1-48.
At 0% or DMX 0, these sliders should be at 0 position,
and at 100% or DMX 255, these sliders should be at
10 position.
4. Once the scene is satisfactory, tap the Record button
to program the scene into the memory as a step.
5. Repeat steps 3 and 4 until all desired steps have been
programmed into memory. You may program up to
1000 steps into memory.
6. Select a chase bank or scene master to store your pro-
gram. Tap the Page button to select a page(Page 1-4)
to store your scenes.
PROCEDURE CONTINUED ON NEXT PAGE
SELECT
MODE
CHNS
A B
DOUBLE
1-24 SINGLE
PRESET
PRESET
SCENES
10
8
6
4
2
0
10
8
6
4
2
0
10
8
6
4
2
0
10
8
6
4
2
0
1 2
RECORD
PAGE
1234
To Next Page
Loading...
