INSTALLATION
15
[7]
For Bio configuration:
1 – unpack the ultrafilter and screw it to the
dispenser.
2 – before that, make sure that the yellow O-
ring is inside the holder;
3 – loosen the degassing valve a little bit to get
rid of air
[8]
Connect the flexible tube’s connectors to the
system
Use the side mounted holder to place dispenser
while it is not in use
[10]
After water dispensing always put
the bell cap back to the bell
The microfilter (or ultrafilter) should be rinsed prior to use!
When the tank is full, press the “Dispense” button and rinse the microfilter (or ultrafilter)
with at least 10 liters (or 20 liters respectively) of purified water.
To Next Page