USING THE SYSTEM
28
[20]
MAINTENANCE
Choose section “Maintenance” if you need to
change modules, calibration or to check
firmware version
[21]
Choose section “Sanitization” if you need to
fulfill sanitization process.
Before the process review the chapter
“Adrona Recirculation Sanitization”
and carry out the necessary
preparatory work
[21 A]
After pressing “Sanitization” the system turns in
“OFF” stage.
Message about sanitization module installation
appears on the screen.
After pressing “OK”, sanitization liquid goes into
the system and sanitization process begins.
[21 B]
[21 C]
[21 D]
Sanitization takes 15 minutes
To Next Page
Loading...