Adrona Q-Front N Trace - Page 29

USING THE SYSTEM
29
[21 E]
The next step is system flushing that takes 15
minutes.
After that, you need to reinstall a pre-filter.
Now system is in working order
[22]
You need to choose section “Purge air” in
following cases:
1 – before recirculation process during the
first installation of the system;
2 – after polishing module replacement;
3 – before installation of dispense port
[23]
System notification during recirculation process
[24]
Choose section “Relieve pressure” if you need:
- to replace a polishing module;
- uninstall a dispenser
[25]
System notification during pressure reduction
process