ADTRAN MX2800 M13 - Table 9-1. TL1 Account Privileges

9-2 61200290L1-1G
Section 9, Transaction Language 1 (TL1) MX2800 M13 Multiplexer User Manual
To bring up a TL1 Telnet connection (up to eight may be active), a Telnet client requests a connection on
TCP port 3116 (port 2024 is used for “RAW TCP” socket access). Once the Telnet connection is estab-
lished, it is necessary to initiate a TL1 session. Establishing a TL1 session involves successful user authen-
tication. Until a TL1 session is established, all commands other than those used to initiate or terminate a
session are denied. Autonomous messaging is also disabled. For information on using the Act-User
command to initiate a TL1 session, refer to TL1 Commands on page 9-5.
NOTE
If RADIUS authentication is enabled, refer to RADIUS Authentication on
page 3-27, the MX2800 attempts to use RADIUS to authenticate TL1
Table 9-1. TL1 Account Privileges
TL1 Command Guest Interface Test Admin
ACT-USER X X X X
ALW-MSG-rr X X X X
CANC-USER X X X X
DLT-USER-SECU X
ED-USER-SECU X
ED-rr (related to loopbacks) X X
ED-rr (configuring alarm relays) X
ED-rr (all remaining) X X X
ENT-USER-SECU X
INH-MSG-rr X X X X
OPR-LPBK X X
REPT-STAT X X X X
RLS-LPBK X X
RTRV-ALM-rr X X X X
RTRV-COND-rr X X X X
RTRV-HDR X X X X
RTRV-rr X X X X
RTRV-SYS X X X X
RTRV-USER-SECU X
RTRV-VER X X X X
SET-DAT X