61200290L1-1G 3-1
SECTION 3, CONFIGURATION
Section 3
Configuration
1. INTRODUCTION
To configure the MX2800, use a 10Base-T Ethernet connection, a SLIP/PPP modem port, or a VT100
terminal. Figure 3-1 shows the Configuration menu.
NOTE
A Telnet menu session has priority over a terminal menu session through
the craft port. If a terminal menu session is active when a Telnet menu
session is initiated, the terminal menu session will be disabled until the
Telnet session is closed.
Figure 3-1. Configuration Menu
Detailed descriptions of the menu selections are given in the following subsections. The Configuration
menu provides the following five submenus:
• Network Interface on page 3-4
To Next Page
Loading...
