NetVanta 3000 Series Hardware Installation Guide Option Modules
61200860L1-34L Copyright © 2006 ADTRAN, Inc. 43
2. OPTION MODULES
The NetVanta 3000 Series (with the exception of the 3120 and 3130) accepts several option modules
designed to meet a variety of networking requirements. The option modules are of two types: plug-in
network interface modules (NIMs) and plug-on dial backup interface modules (DIMs).
NIMs are cards which plug directly into the option module slots (labeled
SLOT 1 NET/DBU or
SLOT
2 NET/DBU), located on the rear of the base unit. These cards provide the following types of
interfaces:
• NetVanta 56K/64K NIM (P/N 1200861L1) on page 47
• NetVanta T1/FT1 NIM (P/N 1202862L1) on page 48
• NetVanta T1/FT1 NEBS NIM (P/N 1200862L2#NEBS) on page 49
• NetVanta T1/FT1 + DSX-1 NIM (P/N 1202863L1) on page 50
• NetVanta Dual T1 NIM (P/N 1200872L1) on page 51
• NetVanta E1/FE1 NIM (P/N 1200868E1/L1) on page 52
• NetVanta E1/FE1 + G.703 NIM (P/N 1200878E1/L1) on page 53
• NetVanta Serial NIM (P/N 1200866E1/L1) on page 54
• NetVanta SHDSL NIM (P/N 1200867L1) on page 55
• NetVanta ADSL NIM, Annex A (P/N 1200869E1/L1) on page 56
• NetVanta ADSL NIM, Annex B (P/N 1200889E1/L1) on page 57
DIMs are plug-on cards which plug directly on to the NIM prior to installation into the base unit. A DIM
must be plugged on to a NIM in order for the
DBU port on the NIM to be active. The NetVanta 3000 Series
supports three DIMs (only one DIM per slot may be installed):
• NetVanta Analog Modem DIM (P/N 1200864L1) on page 58
• NetVanta ISDN BRI DIM (P/N 1200865L1) on page 59
• NetVanta ISDN S/T DIM (P/N 1200875L1) on page 60
• NetVanta Serial DIM (P/N 1200886L1) on page 61
This section describes each module, providing individual card shipping contents, specifications, and
features. Refer to Connector Pin Definitions on page 75 for pinout information. Installing Dial Backup and
Network Interface Modules on page 68 provides information on installating the modules.
To Next Page
Loading...
Need help?
General
