Advanced Control C220 Series - Roup F8 Communication Arameter Escription

Parameter Description
C220/C420G General Flux Vector Control Inverter User Manual
118
setup range
0
～
65535
The user sets the password with this function. The setting methods refer to Password
Setting on Chapter 4 Operation and Display
5.9 Group F8 Communication Parameter Description
F8-00
Baud rate
factory
default
value
5
setup
range
0
300BPS
1
600BPS
2
1200BPS
3
2400BPS
4
4800BPS
5
9600BPS
6
19200BPS
7
38400BPS
This parameter is used to set the data transfer rate between the host computer and the
inverter.
Caution: The baud rate of the host computer and the inverter must be consistent.
Otherwise, communication is impossible. The higher baud rate is, the faster
communication is.
F8-01
Data format
factory default
value
0
setup
0
No check: data format<8,N,2>