25
User Interface
Diagnostics Menu
See Chapter 5 - Troubleshooting and Service.
Setup Menu
Setup allows the user to change the instrument configuration.
1. Set Probe Bin Numbers
Changes the bin numbers for the sample and cooling block
probes.
2. Set Key Beep
Turns the beep on/off when a button is pressed.
3. Set Date and Time
Changes the date and time.
4. Set Serial Rate
Changes the serial rate of the RS-232 port.
5. Set Serial Number
Allows entry of the instrument's serial number.
6. Set Language
Change all messages to the selected language.
7. Feature Lockout
Allows the user to configure which menus are normally avail-
able. The password to make changes is "24".
8. Set 2000 mOsm Calibration
Turns the optional 2000 mOsm/kg H
2
O calibration point on/off.
The instrument has this feature turned ON, and is calibrated
when the instrument is shipped from the factory.
9. Select LIMS Out
Turns on/off the delimited serial output string. See Appendix H
for string format and further information.
NOTE: When “on”, normal serial output is suppressed.
To Next Page
Loading...
Need help?
General
