35
ORIGINAL INSTRUCTIONS | ADVANCED | 01.2022 | 1002021-01 www.advanced.tech
Wheels
Flash valve (Dunlop)
f Deflating: Turn upper valve nut up (anti-clockwise).
f Replacing the valve core: Unscrew upper valve nut
(anti-clockwise).
f Closing the valve: Turn the valve nut down
(clockwise).
7.2 Warnings about the wheels
WARNING
Risk of accident and injury!
If the wheels do not run in a centred manner (concentri-
city), there is an increased risk of accidents and injuries.
The rim can break and rim brakes can lock.
f Have wheels aligned by the bicycle dealer if they run
off-centre or wobble.
WARNING
Risk of accident and injury!
Dirty/missing reflectors impair visibility in road traffic.
There is an increased risk of accidents.
f Remove dirt from the reflectors and replace worn/
missing reflectors immediately.
WARNING
Risk of accident and injury!
If damaged tyres burst while cycling, there is an increased
risk of accidents and injuries.
f Check tyres regularly for damage/wear (→ Chap-
ter 7.4 „Checking wheels“).
f Do not ride the e-bike if the tyres are not intact.
WARNING
Risk of accident and injury!
Operating with incorrect tyre pressure (too high/too low),
leads to increased risk of accidents and injuries.
f Observe the specifications for maximum/minimum
tyre pressure.
f If you are unsure about the correct tyre pressure,
consult a bicycle dealer.
NOTE
Risk of damage
Tyres that do not fit can impair/damage the function of
the e-bike components.
f If you have questions or are unsure about tyre size,
contact a bicycle dealer.
To Next Page
Loading...
General