Advantage Maximum MG Series - Low Tank Level

Maximum Series Portable Chiller : Air & Water-Cooled : MG Series Instrument
update 08/02/2021
Page: 42
ADVANTAGE ENGINEERING, INC.
525 East Stop 18 Road Greenwood, Indiana 46142
317-887-0729 Fax: 317-881-1277
Service Department Fax: 317-885-8683
Email: service@AdvantageEngineering.com
1. Use the Up or Down arrow keys to select the Unit display and then press the
Selectbuttontosaveandconrmsuccess.
2. The factory default value is English.
G. Pressure and Timer Screens. These parameters are factory set and should not be
adjusted without consulting the factory. Changes are recorded in the instrument memory
and adjusting these parameters could void the Factory warranty.
Pressure Related :
• LP Cut Out
• LP Cut In
• HP Cut Out
Timer Related :
• LP Start Up Delay
• LP Run Delay
H. Unit Screens. These parameters are factory set and should not be adjusted without
consulting the factory. Changes are recorded in the instrument memory and adjusting
these parameters could void the Factory warranty.
• Secondary Pump
• Chiller Type
• Cooling Source
3.11 LOW TANK LEVEL
A. Mostmodelsincludealevelswitchthatmonitorsthetankuidlevelandprovidesa
warningwhenthetanklevelislowandneedstoberelled.
Typical Level Switch shown.
In some models, the level switch is placed
behind a stainless steel barrier to isolate
the level switch from water turbulence in the
reservoir tank.