How to unlock the temperature controller settings on my AEC Dryer?
You cannot change settings on the temperature controller of your AEC Dryer if the key protection switch is set to ON. Set the key protection switch to OFF.
Provides guidance on mechanical installation, emphasizing secure attachment and safe lifting practices.
Explains the meaning of safety terms (NOTICE, CAUTION, WARNING, DANGER, IMPORTANT) and how to report safety defects.
Emphasizes the importance of safety for owners, operators, and maintenance personnel, linking it to productivity and accident prevention.
Details the operator's role in safe dryer operation, stressing awareness of capabilities, limitations, and workplace safety rules.
Highlights safety priorities for maintenance workers and outlines essential steps before removing, adjusting, or replacing parts.
Provides information on safety devices and procedures inherent to the AD Dryer, aiming to supplement standards for a safer working environment.
Provides guidance on rigging and placing the dryer, referencing figures for safe rigging diagrams and lifting lugs.
Details how to make electrical connections, emphasizing voltage, phase, electrician qualifications, and grounding.
Explains how to check for proper blower rotation, especially for three-phase models, to avoid desiccant contamination.
Provides instructions on how to set the process air temperature on the dryer, consulting resin manufacturers for recommendations.
Details essential pre-startup checks, including hose connections, companion equipment, and electrical connections.
Provides a step-by-step guide for starting up the dryer, including power-up, hopper fill, and setting the temperature controller.
Explains the procedure for shutting down the dryer after processing is complete, including companion equipment and electrical disconnects.
Outlines maintenance work rules, emphasizing safety, following instructions, and using approved tools.
Provides instructions for replacing worn desiccant, including safety precautions for handling hazardous desiccant material.
Details the procedure for replacing the process heater element, emphasizing hazardous electrical current and lockout procedures.
Guides on replacing or cleaning regeneration heater and cooling coils, stressing hazardous electrical current and lockout.
General| Model | AD Series |
|---|---|
| Category | Dryer |
| Capacity | Varies by model |
| Power Source | Electric or Gas |
| Drum Material | Stainless Steel |
| Heat Source | Electric or Gas |
| Temperature Range | Varies by model |
| Warranty | Varies by model and region |
To Next Page
