Connecting the machine
Attention:
Always make sure that the machine is
unplugged from power source and the
main switch is on ("O") when the machine is
not in use and before inserting or removing
parts.
Foot Control
With the sewing machine turned o, insert
the foot control plug into its connector on
the sewing machine.
Turn on the sewing machine, and then slowly
depress the foot control to start sewing.
Release the foot control to stop the sewing
machine.
Before connecting the power supply, make
sure that the voltage and the frequency
shown on the rating plate conform to
your mains power. Place the machine on a
stable table.
1. Connect the machine to a power
source as illustrated.
2. Turn on the power switch.
3. The sewing lamp will light up when the
switch is turned on.
Note:
Consult a qualified electrician if in doubt
as to connect the machine to the power
source.
8
To Next Page
Loading...
