Free motion darning, embroidery and
monogramming
Preparation for embroidering
and
monogramming
* Embroider hoop is not included with the
machine.
-
Install the darning plate, see page 45.
-
Remove the presser foot and the presser
foot holder.
-
Draw the desired lettering or design on
the right side of the fabric.
-
Stretch the fabric between the
embroidery hoop as firmly as possible.
-
Place the fabric under the needle. Make
sure the presser foot bar is down to its
lowest position.
-
Turn the balance wheel towards you to
bring up the lower thread through the
fabric. Sew a few securing stitches at the
starting point.
-
Hold the hoop with thumb and
forefinger of both hands while pressing
the material with the middle and third
finger and supporting the outside of the
hoop with your small finger.
Caution:
Keep fingers away from moving parts,
especially needles.
0 3.5~5
Stitch Length Stitch Width
46
To Next Page
Loading...
