Replacing the needle
Attention:
Turn the power switch to o ("O") when
carrying out any of the above operations!
Change the needle regularly, especially
when it shows signs of wear or causes
problems.
Insert the needle following the illustrated
instructions.
1. Turn the handwheel towards you
(counterclockwise) lowering, then
raising the needle. Turn the needle
clamp screw counterclockwise to
remove the needle. The flat side of the
shaft should be positioned towards
the back.
2. Insert the needle as far up as it goes.
Next, tighten the needle clamp.
Needles must be in perfect condition.
Problems can occur with:
Bent needles
Blunt needles
Damaged points
1
2
1
2
3
1
2
3
20
To Next Page
Loading...
