Aerco AM Series - Material and Tool Requirements

AM Series Boiler Heat Exchanger Maintenance & Replacement
Technical Instruction Document
Material and Tool Requirements
The following tools and materials are required to perform the heat exchanger replacement
procedure.
Piece of Wood (roughly 20” x 2-1/2” x 1/2”)
10mm Nut Driver (19” Length) or 10mm Socket Wrench and Extension
Phillips Screwdriver (TOR x 20”)
46mm Pipe Wrench or Adjustable Wrench
30mm Pipe Wrench or Adjustable Wrench
Wrench (10mm)
Gasket
(P/N 60702096)
Gasket
(P/N 60702097)
Gasket x2 (1-1/4” Dia.)
(P/N 60701007)
Gasket (3/4” Dia.)
(P/N 607001006)
Silicone Grease
Scotch Tape
(or equivalent)
Air Compressor
Page 3 of 36 AERCO International, Inc. • 100 Oritani Dr. • Blauvelt, NY 10913 TID-0137_0A
02/02/2015 Ph.: 800-526-0288