Need help?Do you have a question about the AERMEC HMI Series and is the answer not in the manual?
General| Brand | AERMEC |
|---|---|
| Model | HMI Series |
| Category | Air Conditioner |
| Language | English |
Describes the primary display screen and its interactive elements.
Outlines the structure and content of the 'Function' menu section.
Outlines the structure and content of the 'View' menu section.
Outlines the structure and content of the 'Parameter' menu section.
Details the functions available within the Commission menu for unit setup.
Details the parameters available within the Commission menu for unit setup.
Covers general settings and system-wide configurations.
Explains how to power the unit on and off using the control interface.
Describes the process of navigating and selecting different menus on the unit.
Guides users on how to move through and interact with the Function menu.
Details how to select and change the unit's operating mode (Heat, Cool, etc.).
Explains how to enable rapid domestic hot water heating.
Configures the priority between cooling and DHW production.
Configures the priority between heating and DHW production.
Describes how to activate and configure the noise reduction feature.
Explains automatic set-point adjustments based on external air temperature.
Details how to program daily on/off times for unit operation.
Allows enabling holiday program settings for the weekly timer.
Explains how to manage the anti-legionella disinfection cycle.
Configures timed operations for unit start and stop.
Adjusts water delivery set-points based on time.
Activates emergency mode for heating or DHW production.
Configures the unit for absence periods, often in winter.
Sets up daily operating periods with specific commands.
Resets active error conditions on the unit.
Resets the unit's WiFi connection to resolve conflicts.
Restores factory default settings for all functions.
Guides users on how to navigate the Parameter menu.
Configures temperature set-points for different operating modes.
Guides users on how to navigate the View menu.
Displays the operational status of various unit components.
Shows the current operational values of the unit's parameters.
Lists current errors and alarms active on the unit.
Displays the historical log of unit errors and alarms.
Shows the installed software version of the unit.
Guides users on navigating the Commission menu for advanced setup.
Configures the unit's control logic based on water or ambient temperature.
Sets the operational status of the 2-way valve during cooling.
Sets the operational status of the 2-way valve during heating.
Configures integration with solar systems (function not available).
Specifies if a DHW storage tank accessory is installed.
Configures the usage type of an external thermostat.
Manages the activation and logic for an additional heat source.
Configures and activates optional electric heaters.
Enables or disables the remote room temperature probe.
Activates air circulation to remove air from the circuit.
Sets up a procedure for pre-heating radiant panels.
Manually activates or deactivates a forced defrost cycle.
Forces specific heating or cooling functions.
Manages switch-on/off commands via an external contact.
Setting for maximum absorption limit (currently not available).
Assigns a serial address to the unit for Modbus control.
Activates/deactivates refrigerant recovery for maintenance.
Manages the electric heater logic for accessory tanks.
Activates/deactivates storage of settings for external contact functions.
Sets the max DHW tank temperature achievable by the heat pump.
Stabilizes terminal temperature after reaching set-point.
Stabilizes terminal temperature after reaching set-point for heating.
Guides users on navigating the Main Menu.
Changes the temperature unit between Celsius and Fahrenheit.
Enables/disables saving of parameter/function settings.
Turns the touch sound signal on or off.
Configures the display brightness or energy-saving mode.
Sets the current date and time for the system.
Allows selection of the user interface language.
Activates the WiFi signal for app control.
Provides information on connecting via ModBus RS485.
To Next Page
