16
00 00
01 01
02 02
23 59
22 58
Clock timer
Clock timer: Off
Mode: Heat
Period: 00:00~00:00
T water tank: 50°C
WOT Heat: 45°C
4.11. Setting a timed switch-on/switch-o (Clock timer)
After accessing the “Clock timer” function, you will be
able to set all the parameters needed for a timed start
of the unit:
• “Clock timer” = enable or disable the timer
• “Mode“ = select the mode to be used during the time
band (each click changes the mode)
• “Period“ = access this page to set the start and
end time for the time band
• “T-tank ctrl.“ = set (if the mode so envisages) the
set for the domestic hot water production stor-
age tank
• “WOT-heat“ = set the value (if envisaged) for the
water production set-point (terminal system
side)
Click on the “Period” label to open the page with the
timer start and end time labels; set by first of all click-
ing on the label of the time you want to set, then slid-
ing your fingertip over the time values until you select
those required. Lastly, press the top right button to
save the data entered.
Click on the labels for parameters with numeric values
to be inserted to display a numeric keypad (with an
indication of the range of permitted values) which you
can use to enter the required values.
00 00
01 01
02 02
23 59
22 58
Clock timer
Start timer: 00:00
End timer: 00:00
00 00
01 01
02 02
23 59
22 58
Min: 20 Max: 60
X
0
1 2 3
4 5 6
7 8
0 -
9
OK
00 00
01 01
02 02
23 59
22 58
Clock timer
Clock timer: Off
Mode: Heat
Period: 00:00~00:00
T water tank: 50°C
WOT Heat: 45°C
NOTES:
1. If the requested mode is “Hot water”, the “WOT-Cool” or “WOT-heat“ parameter will not be displayed.
2. Every time you press on the label, the value will change. Once you have selected the required value,
press the icon to save and implement the setting.
3. If the compatible Aermec accessory tank for this model (refer to the installation manual for more
information) is not installed and correctly set, the references to hot water production will not be
available.
4. If the weekly timer and the standard timer are set at the same time, the weekly timer takes priority.
5. The timer start must always be prior to the timer end, otherwise the period will not be valid.
To Next Page
Loading...
Need help?
General
