10
After accessing the “Fast hot water” function, you can
choose whether to activate - along with the unit com-
pressor - the electric heater inserted in the compatible
Aermec accessory tank (specific for this model) for
the production of domestic hot water. To activate this
function, click directly on “ON” and then confirm with
“ O K ”.
Fast hot water
On
Off
OK Cancel
NOTES:
1. If the compatible Aermec accessory tank for this model (refer to the installation manual for more
information) is not installed and correctly set, this function will not be available.
2. To ensure even better energy saving, it is advisable to disable this function.
3. If the relative function is activated (paragraph 8.3), the value of this parameter will be stored in the
memory and automatically reset after any possible voltage failure.
4. The default value for this parameter is: “Off“.
4.3. Activating the function for fast domestic hot water production (Fast hot water)
After accessing the “Cool+hot water” function, you
can select “Cool” to force the unit to first of all satisfy
the system terminal side; by selecting “Hot water”, pri-
ority is given to domestic hot water production. Select
the priority, then press “OK” to confirm.
Cool + hot water
Hot water
Cool
OK Cancel
NOTES:
1. If the compatible Aermec accessory tank for this model (refer to the installation manual for more
information) is not installed and correctly set, this function will not be available.
2. If the relative function is activated (paragraph 8.3), the value of this parameter will be stored in the
memory and automatically reset after any possible voltage failure.
3. The default value for this parameter is: “Cool”.
4.4. Setting the priority between cooling and domestic hot water production (Cool+hot water)
To Next Page
Loading...
Need help?
General
