AERMEC HMI Series User Manual

26
Cool 2 way valve
On
Off
OK Cancel
NOTES:
1. If you select the “Off” status, the valve will be CLOSED in cooling mode; it will be OPEN if you select
“ O n ”.
2. If the relative function is activated (paragraph 8.3), the value of these parameters will be stored in the
memory and automatically reset after any possible voltage failure.
7.3. Setting the status of the 2-way valve in cooling mode (Cool 2-Way valve)
After accessing the “Cool 2-Way valve” function, you
can set the status of the 2-way valve in cooling mode
(for more information about the assembly and use of
the 2-way valve, refer to the installation manual). Se-
lect the required logic, then press “OK” to confirm.
After accessing the “Heat 2-Way valve” function, you
can set the status of the 2-way valve in heating mode
(for more information about the assembly and use of
the 2-way valve, refer to the installation manual). Se-
lect the required logic, then press “OK” to confirm.
Heat 2 way valve
On
Off
OK Cancel
NOTES:
1. If you select the “Off” status, the valve will be CLOSED in heating mode; it will be OPEN if you select
“ O n ”.
2. If the relative function is activated (paragraph 8.3), the value of these parameters will be stored in the
memory and automatically reset after any possible voltage failure.
7.4. Setting the status of the 2-way valve in heating mode (Heat 2-Way valve)
Function currently NOT AVAILABLE.
WARNING: this function is not currently available, so its setting must necessarily be “Without”.
7.5. Setting solar system integration (Solar setting)

AERMEC HMI Series Specifications

General

Brand	AERMEC
Model	HMI Series
Category	Air Conditioner
Language	English