AERMEC NSMI C-Touch User Manual

19
11 TIME BAND MENU
With the TIME PERIODS menu you can set the time periods to be used in the hourly
programming of the unit.
 NOTE: The top-left corner of each window shows which compressor is currently
providing the displayed data (U:1,2,3 o 4); to switch between compressors (only
possible from Master unit), refer to that explained in paragraph "3.3Unit operating
status information (real time data)p.7".
11.1 PAGE FOR CREATING TIMED PROGRAMS
— Indicates to which compressor the displayed data refers (U:1 = Master; U:2 =
Slave 1; U:3 = Slave 2; U:4 = Slave 3)
— Allows deciding whether to enable or not the time periods (YES = enabled; NO
= not enabled)
— Indicates which day the visualised time settings apply to
— Allows establishing the start time of the rst available time period
— Allows establishing the end time of the rst available time period
— Allows establishing the start time of the second available time period
— Allows establishing the end time of the second available time period
— Allows establishing the start time of the time period for the Night Silent func-
tion (7.8DCP Settings or inverter fansp.13)
— Allows establishing the end time of the time period for the Night Silent function
(7.8DCP Settings or inverter fansp.13)
12 LANGUAGE MENU
The LANGUAGE menu is used to modify the interface language for the various men-
us. The system language is usually set in the factory, according to the country where
the unit will be used, but it can be altered at any time via this menu.
12.1 PAGE FOR SELECTING THE SYSTEM LANGUAGE
— Used to set Italian as the system language
— Used to set English as the system language
— Used to set German as the system language
— Used to set French as the system language
— Used to set Spanish as the system language
13 HELP MENU
Menu protected and blocked by a password.
WARNING: this menu contains parameters that may cause malfunction-
ing if they are incorrectly set. For this reason, only technical maintenance
personnel or other authorised personnel may access this menu. For more
information, contact After Sales Service.
14 MULTIPURPOSE INPUT MENU
With the MULTI-FUNCTION INPUT menu you can set the function to be assigned to
multi-function input U7 (MASTER).
14.1 DISPLAYS THE STATUS OF MULTIFUNCTION INPUT U7
A
— Indicates to which compressor the displayed data refers (U:1 = Master; U:2 =
Slave 1; U:3 = Slave 2; U:4 = Slave 3)
— Indicates whether the multi-function input has been enabled or not (this ena-
bling can only be set by the after-sales assistance personnel)
— Indicates the value read on analogue input U7 (this enabling can only be set by
the after-sales assistance personnel)
A. Value reserved for after-sales assistance

AERMEC NSMI C-Touch Specifications

General

Brand	AERMEC
Model	NSMI C-Touch
Category	Control Panel
Language	English