1. GENERAL WARNINGS
The WRL-H AERMEC heat pumps
are constructed according to the
recognised technical standards
and safety regulations. They are
designed for summer and winter
conditioning and the production of
domestic hot water. Any contractual
or extracontractual liability of the
Company is excluded for injury/
damage to persons, animals or objects
owing to installation, regulation and
maintenance errors or improper use.
All uses not expressly indicated in this
manual are prohibited.
1.1. PRESERVATION OF THE
DOCUMENTATION
The instructions along with all the
related documentation must be given
to the user of the system, who assumes
the responsibility to conserve the
instructions so that they are always at
hand in case of need.
Read this sheet carefully; the execution
of all works must be performed by
qualified staff, according to Standards
in force on this subject in different
countries. (Ministerial Decree 329/2004).
1.2. INSTALLATION
The unit must be installed in such a way
that maintenance and/or repairs can
be carried out.
1.3. WARRANTY
The appliance warranty does not cover
the costs for ladder trucks, scaffolding,
or other elevation systems that may
become necessary for carrying out
servicing under warranty.
Do not modify or tamper with the heat
pump as dangerous situations can be
created and the manufacturer will not
be liable for any damage caused. The
validity of the warranty shall be void in
the event of failure to comply with the
above-mentioned indications.
1.4. WARNINGS REGARDING SAFETY AND
INSTALLATION STANDARDS
− The cooler must be installed by
a qualified and suitably trained
technician, in compliance with the
national legislation in force in the
country of destination (Ministerial
Decree 329/2004).
AERMEC will not assume any
responsibility for damage due to
failure to follow these instructions.
− Before beginning any operation,
READ THESE INSTRUCTIONS CAREFULLY
AND CARRY OUT THE SAFETY CHECKS
TO AVOID ALL RISKS. All the staff
involved must have thorough
knowledge of the operations and
any dangers that may arise at the
moment in which the installation
operations are carried out.
example of technical plate
Standards and Directives re-
spected when designing and
constructing the unit:
Safety:
Machinery Directive
2006/42/CE
Low Voltage Directive
LVD 2006/95/CE
Electromagnetic Compatibil-
ity Directive
EMC 2004/108/CE
Pressure Equipment Directive
PE
D 97/23/CE EN 378,
UNI EN 14276
Electric part:
EN 60204-1
Acoustic part:
SOUND POWER
(EN ISO 9614-2)
SOUND PRESSURE
(EN ISO 3744)
Certifications:
Eurovent
Refrigerant GAS:
This unit contains fluoride
gases with greenhouse ef-
fect covered by the Kyoto
Protocol. Maintenance and
disposal must only be per-
formed by qualified staff.
ATTENTION
Tampering, removal, lack of
the identification plate or
other does not allow the safe
identification of the product
and will make any installation
or maintenance operation to
be performed difficult.
2. PRODUCT IDENTIFICATION
The WRL-H heat pumps can be
identified by:
− PACKING LABEL
which shows the product
identification data
− TECHNICAL PLATE (see position chap.
2.1.).
2.1. TECHNICAL PLATE POSITION
6
IWRLTY. 1201. 5890974_06
To Next Page
Loading...
Need help?
General
