GES – Users Manual
Page 12 of 33
6.4. Example
This is an example of the interaction with the GES command line interface.
The following actions are performed:
• Change to the configuration menu
• Show the current extra configuration
• Update the Primary IP
• Show the new configuration
Note: characters input by the user are in bold.
Main Menu
Cmd Description
d display statistics
u display UIP statistics
1 MAC port status
2 PHY port status
o dump MIB counts
c go to configuration menu
GES>c
GES Software Version: 4.3
GES Bootloader Version: 7
Hardware Serial Number: 1002
MAC Address: 00:0B:D1:08:10:02
FDB Table Index: 984
IP Address[0]: 192.168.1.100
IP Mask [0]: 255.255.255.0
IP Address[1]: 172.31.129.100
IP Mask [1]: 255.255.255.0
temperature: 43 C
Configuration Menu
Cmd Description
c show configuration
p set primary IP address and netmask
s set secondary IP address and netmask
d set mirror destination
m set port mirror details
u set cpu mirror details
f write out current config to flash
b back to main menu
GES>c
IP_address[0]: 6401A8C0 (192.168.1.100)
IP_address[1]: 64811FAC (172.31.129.100)
To Next Page
Loading...
General