61
2. Mark and Drill hole to accommodate fuel filler
dot.
3. Fuel filler dot installed shown below.
4. Locate the supplied Rubber grommets as shown
below.
Note: We have supplied rubber grommets for you
to route the fuel line through to give a
finished professional look.
5. Determine the vent line hole location at the bot-
tom fuse hatch cover. Mark and drill a hole and
install the fuel line rubber grommet. The rubber
grommet will help prevent the fuel line from
shaving or cutting and keep the balsa wood from
cracking.
Note: Your hatch cover may look different then
shown below. Vent line and grommet
installation steps will be the same.
To Next Page
Loading...
