69
9. Be sure to get the 3/8” reference line you previ-
ously drew lined up with the front edge of the
fuselage as shown
10. Trace around the cylinder head of the motor be-
ing careful to keep the template in the same loca-
tion.
Note: Mark Cowl Side on template for easy
reference when placing template on cowling
11. Remove the template. Using a hobby knife cut
around the lines you just created to make a hole
for the cylinder head.
12. Reattach the template and check to see if the
template lines up correctly. It may be necessary
to make small adjustments to the cut out at this
time.
To Next Page
Loading...
