75
7. Insure Dummy radial is centered in cowling and
the position of the dummy cylinders are located
correctly. The air inlet cut out should be directly
over the engine cylinder. Once satisfied with the
location of the dummy radial tighten the jig bolt
firmly into place
8. Gather Thick CA glue and a good quality Sili-
cone glue.
Note: We recommend Zap all purpose adhesive
for best results
9. Run a bead of Thick CA glue around the edge of
the dummy radial engine.
10. Once the CA has cured. Run a bead of Silicon
glue around the edge of the dummy radial en-
gine.
To Next Page
Loading...
