AGFA CR 75.0 - Page 63

63
2241A EN 20040210
10 Wait until the display reads:
You must make new backup files with the new parameters.
11 Insert an empty formatted floppy into the disk drive and press the Confirm key.
The CR 75.0 will start copying the machine specific configuration data while
displaying the Save configuration screen:
12 When the screen below is displayed, note the serial number, the date, and
the software version.
13 Remove the floppy from the disk drive and label it with the data from the screen.
14 Store the CR 75.0 language floppy and the backup floppy in the storage box.
15 Close the front doors.
The CR 75.0 will restart automatically.
After start-up, the operator main screen will be displayed.
Parameters have changed.
You should refresh your
backup now.
Please insert the backup
floppy and press
: quit
: ok
INSTALL
LANGUAGE
SERVICE XXXXX
copying . . .
D:\ACP_<serial#>.zip
to
A:<path><file name>
: quit
: ok
SAVE
CONFIGURATION
SERVICE XXXXX
Machine configuration
saved. Label the floppy
Backup CR 75.0
S/N: <serial#>
Date: <date>
SW version: ACP_XXXX
Please remove the floppy
and press
: ok
SAVE
CONFIGURATION
SERVICE XXXXX