69
2241A EN 20040210
13 When the screen below is displayed, note the serial number, the date, and
the software version.
14 Remove the floppy from the disk drive and label it with the data from the screen.
15 Store the floppy with the CPF-files of the CR 75.0 and the backup floppy in
the storage box.
16 Close the front doors.
The CR 75.0 will restart automatically.
After start-up, the operator main screen will be displayed.
Machine configuration
saved. Label the floppy
Backup CR 75.0
S/N: <serial#>
Date: <date>
SW version: ACP_XXXX
Please remove the floppy
and press
: ok
SAVE
CONFIGURATION
SERVICE XXXXX
To Next Page
