DR Detector cable
The DR Detector cable connects the DR Detector to the System Control Unit.
The DR Detector cable can be used for two different functions. Which of two
functions is enabled, is selected at installation. Both functions cannot be
enabled on the same detector.
1. The DR Detector is configured for wireless operation. The cable is used for
registering a shared DR Detector on another NX workstation.
2. The DR Detector is configured for wired operation. The cable is used to
power the DR Detector and to transmit image data.
Related Links
Registering the DR Detector on another NX Workstation on page 94
Charging the battery using the DR detector cable on page 93
18 | DX-D 45C, DX-D 45G | Introduction to the DR Detector
0292B EN 20190401 1627
To Next Page
Loading...
