Stopping the DR Detector
To stop the DR Detector:
1. Turn off the detector.
Press and hold the power button (approx. 3 seconds).
All the status indicator lights are off.
2. While holding down the battery pack, slide the lock levers toward
(unlock) (1), put your fingers on the battery edge that lifts up, and then
pull the edge to remove the battery pack (2).
a) Open the cover of the battery slot
b) Push the lock lever to the left to unlock the battery.
c) Slide the battery out of the battery slot.
d) Close the cover of the battery slot.
Note: When the detector will not be used for some time, remove
the battery. Otherwise, overdischarge may occur, leading to a
shorter battery life.
86 | DX-D 45C, DX-D 45G | Getting started
0292B EN 20190401 1627
To Next Page
Loading...
