Daily inspection
WARNING:
For safety reasons, be sure to turn OFF the power to each piece
of equipment before performing the following. Otherwise, an
electric shock may result.
Detector
1. Ensure that cables are not damaged and cable jackets are not torn.
2. Ensure that the power cord plugs are securely connected to both the
equipment AC inlet and the AC outlet.
Cable
3. Ensure that there are no loose screws or breaks.
4. Ensure that there is no dust or foreign matter on the battery bay
connector.
5. Ensure that there are no breaks or short-circuits in the battery bay
connector.
Turn on the power. Start the NX workstation and perform a test exposure.
56 | DX-D 45C, DX-D 45G | Introduction to the DR Detector
0292B EN 20190401 1627
To Next Page
Loading...
