33
2321 E EN 20130722
DX-G/DX-M
Cleaning the exterior of the digitizer
To clean the exterior of the digitizer:
1 Switch off the digitizer.
2 Remove the power plug from the socket.
Switch off the UPS, if installed.
3 Wipe the exterior of the digitizer with a clean, soft, damp cloth.
Use a mild soap or detergent if required but never use ammonia-based cleaner.
4 Plug the power plug into the socket.
Switch on the UPS, if installed.
Cleaning the touch panel
To clean the touch panel:
1 Switch off the digitizer.
2 Remove the power plug from the socket.
Switch off the UPS, if installed.
3 Wipe the touch panel of the digitizer with a clean, soft, damp cloth. Use a com-
mercially available screen cleaner for monitors to clean the touch panel.
Caution: Make sure no liquid gets in the digitizer.
Note: Do not open the digitizer for cleaning. No components inside the
digitizer require cleaning by the user.
Caution: Do not pour liquid directly on the touch panel.
To Next Page
Loading...
