Do not use this equipment in combination with peripherals such as
defibrillators or large electric motors as these may cause power-supply noise
or power supply voltage variations. Doing so may prevent normal operation of
this equipment and peripherals.
Sudden heating of the room in cold areas will cause condensation to form on
the equipment. In this case, wait until the condensation evaporates before
use. If the equipment is used while condensation is formed on it, problems
may occur. When an air-conditioner is used, be sure to raise/lower the
temperature gradually so that a difference in temperature in the room and in
the equipment does not occur, to prevent condensation.
WARNING:
Do not use non-medical equipment in the patient’s vicinity.
Figure 10: Patient’s vicinity
XD 14, XD⁺14 | Introduction to the DR Detector | 39
0430A EN 20210426 1355
To Next Page
Loading...
