Installing Logic Analyzer Cards and Probes 2
16900 Series Logic Analysis Systems Installation Guide 37
16960A Logic Analyzer (1-card module)
A single- card module can be installed in any available slot.
For a single card, the two 16960- 61601 flex cables (kit 16960- 60001 in the
accessory pouch) are not used.
The order of pods on the card’s rear panel is:
In a multi- card set, pods are indexed from the bottom up. Because clock
signals can be input to any card in the set (on pod 1 or 3), cards do not
have master and expander designations.
Turn off the mainframe power before removing, replacing, or installing modules. For
instructions on installing modules into the logic analysis system frame, refer to page 26.
To Next Page
Loading...
Need help?
General
