Setting Up Multiframe Configurations 5
16900 Series Logic Analysis Systems Installation Guide 97
application on one of the frames. If it does, then simply exit the
application. If it does not, then fix the problem on that frame first.
b Verify that the firewalls on all frames are set up properly with the
proper exceptions (see “To restore the logic analysis system firewall
defaults” on page 109).
c On the performance PC, do not block outbound traffic to port 16900.
d The Refresh button in the Select System to Use dialog should show
the status of the multiframe logic analysis system as "Available".
e Validate that you have properly configured the network setup on each
of the systems. All systems must be able to communicate with each
other over the multiframe cable and over the LAN.
Remotely Controlling a Performance Multiframe System
If you want to control the performance multiframe system remotely, there
is only one option:
• Use one of the remote window utilities to remotely control the
performance PC. Choose from Remote Desktop, RealVNC, or NetOp. You
will need to set up this service on your performance PC and your local
PC.
To Next Page
Loading...
Need help?
General
