140
Chapter 6 Service
Disassembly
6
Disassembly
The following tools are recommended for disassembly.
•T15 Torx
®
driver (all screws)
• 11 mm nut driver (front-panel disassembly)
• 14 mm nut driver (rear-panel BNC connectors)
• 5 mm nut driver (rear-panel RS-232 connector)
• #1 Pozi-Drive (for display assembly)
WARNING SHOCK HAZARD. Only service-trained personnel who are aware
of the hazards involved should remove the instrument covers.
To avoid electrical shock and personal injury, make sure to
disconnect the power cord from the instrument before removing
the covers.
Torx
®
is a registered trademark of Camcor/Textron, Inc.
To Next Page
Loading...
