Why did the front panel EEPROM checksum test fail on my Agilent Technologies 6674A?
The front panel EEPROM checksum test might have failed on your Agilent Technologies Power Supply possibly due to power loss during a write operation. If power loss is not the problem, the EEPROM A1U6 could be defective.
What causes EEPROM write failure in Agilent Technologies 6674A?
EEPROM write failure in Agilent Technologies Power Supply may be caused by a defective EEPROM A1U6 or a calibration error.
General| Output Voltage | 0 to 60 V |
|---|---|
| Number of Outputs | 1 |
| Line Regulation | 0.01% + 2 mV |
| Programming Accuracy Current | 0.1% + 5 mA |
| Input Frequency | 47 to 63 Hz |
| Operating Temperature Range | 0 to 50 °C |
| Storage Temperature Range | -40 to 70 °C |
| Cooling | Forced air |
| Current Ripple and Noise (20Hz to 20MHz) | 5 mArms |
| Relative Humidity | 0 to 95% non-condensing |
| Load Regulation | 0.01% + 2 mV |
To Next Page
