3-92
Function Reference
Take Sweep
Take Sweep
For 86141B/86144B/86146B Filter Mode only.
Initiates a single sweep that updates the display to show the valid waveform
data. Refer to “Repeat Sweep” on page 3-71 and to “Single Sweep” on
page 3-86.
Key Path Appl’s > Measurement Modes > Filter Mode > Switch Path Auto Align Now
> Take Sweep
Related Functions Single Sweep
Remote
Commands
INITiate:IMMediate
Title (Display Setup Panel)
Turns the display title on or off. When the title selection is on, the title will
appear on the display’s top, center of the graticule, and on printouts. Create a
title in the Title Setup panel (System > Set Title). Use the arrows, step keys,
or knob to select the letters for the title. See “Adding a Title to the Display” on
page 2-19.
Key Path System > More System Functions > Display Setup
Remote
Commands
DISPlay:WINDow:TEXT:DATA
Trace Averaging
When averaging is on, you can select the number of measurement sweeps to
be averaged, using the 10, 20, 50, 100 softkeys. You can also enter averaging
values other than those displayed by using the numeric keypad or the knob.
To Next Page
Loading...
Need help?
General
