3-96
Function Reference
Trigger Mode, Internal
Remote
Commands
[SENSe]:POWer:RANGe:LOCK
Trigger Mode, Internal
Synchronizes the start of the sweep to an internally generated trigger signal.
Internal triggering ensures continuously triggered sweeps with the shortest
delay between sweeps. See “Triggering a Measurement” on page 2-10
Key Path Bandwidth/Sweep > More BW/Sweep Functions > Trigger Mode
Remote
Commands
TRIGger[:SEQuence]:SLOPe
TRIGger[:SEQuence]:SOURce
Update A...F On|OFF
When on, the selected trace is updated after each sweep. When off, the trace
data is not updated.
Key Path Traces > Update
Related Functions View A...F
Remote
Commands
SENSe:SWEep:POINts
TRACe:FEED:CONTrol TRA|TRB|TRC|TRD|TRE|TRF,ALWays
TRACe:FEED:CONTrol TRA|TRB|TRC|TRD|TRE|TRF,NEVer
Use Marker Search Threshold On/Off (Marker Setup
Panel)
When on, the marker search function ignores peaks below the threshold value.
A dotted line is shown on the display at the threshold level.
Key Path Markers > Marker Setup > Use Marker Search Threshold
To Next Page
Loading...
Need help?
General
