32 Agilent Gas Sample Selector for 8860 and 8890 Safety and Installation Manual
3 Installation
Before You Begin
Before You Begin
The Selector requires an Agilent 8890 or 8860 GC that meets the following
requirements:
• Firmware version 2.2 or later.
• Agilent GC Driver version 3.4 or later.
• A Gas Sampling Valve accessory is installed.
• The Gas Sampling Valve must be configured as valve type Other (not as a
sampling valve).
NOTE
You must install the Gas Sampling Valve and update firmware and driver before
installing the Selector, if needed. To obtain the latest GC firmware and driver,
contact your Agilent support representative.
To Next Page
Loading...
Need help?
General
