3-18 Chapter 3
Making GSM Base Station Measurements
Making The Power Steps Measurement
• Measurement setup parameters.
These are measurement specific parameters changed using the
Measurement setup (
Meas Setup) menu. Parameters can be returned
to default settings at any time by pressing
Meas Setup and Restore
Meas Defaults
. For further information on measurement setup
parameters, refer to the ESA-E Series Spectrum Analyzers GSM
Measurement Personality User’s Guide.
NOTE Parameters that exist under the Meas Setup Advanced key seldom need
to be changed. Any changes from the default values may result in
invalid measurement data.
Results
An example screen from a Power Steps measurement is shown below in
Figure 3-11
Figure 3-11 Power Steps Measurement
To Next Page
Loading...
