Performance Tests 2
E4416A/E4417A Power Meters Service Guide 17
Performance Test Record
Performance test results can be recorded in Table 2- 9, “Performance Test
Record” on page 57. The Performance Test Record table lists the performance
test specifications and the acceptable limits for each specification.
Calibration Cycle
Agilent E4416A and E4417A power meters require performance tests to be
run every two years to verify that they are operating within specified
tolerances. Under conditions of heavy usage or severe operating
environments, this calibration cycle should be performed more frequently.
Test Procedures
It is assumed that the person performing the tests understands how to operate
the specified test equipment. Equipment settings, other than those for the
power meter, are stated in general terms. It is assumed that the person will
select the proper cables, adapters, and probes required for test setups
illustrated in this chapter.
Thermistor Mount Option
The following thermistor mount options are offered:
• 478A Option H75 with VRC at 200 Ω only (reflection and correction data
provided.
• 478A Option H76 with VRC at 200 Ω only (reflection and correction data
provided.
• 478A Option H77 with VRC at 100 and 200 Ω (reflection and correction data
at 50 MHz only).
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General
