Agilent Technologies E5061B - Outer Cover Replacement

Chapter 4 53
Replacement Procedure
Required Tools
4. Replacement Procedure
Required Tools
The following tools are required for repair of E5061B.
Table 4-1 Required Tools
Assembly torque screwdriver flat edge
screwdriver
hex key box torque
driver
box torque
wrench
open torque
wrench
T8 T10 T15 T20 1.5 mm 5.5 mm 9/16 in. 5/8 in. 5/16 in.
Outer Cover √ √
Front Panel √ √ √
Hard Disk Assembly √ √ √
Power Supply
Assembly
√ √ √ √
A50 CPU Module √ √ √
A60 CPU Module √ √ √
24 Bit I/O Assembly √ √ √ √
DSP Assembly √ √ √ √ √
A9 LF Source Bias
Module
√ √ √ √
A2 Receiver Module √ √ √ √ √
A3/A4 Receiver
Module
√ √ √ √ √
A1 Source Module √ √ √ √ √
A11 Source Module √ √ √ √ √
A10 Analog Mother
Board
√ √ √ √ √ √ √
Ref Oven √ √ √ √
Fan Assembly √ √ √ √
Angle (for Fan
Assembly)
√ √ √ √
Touch Screen Control
Board
√ √ √ √
Inverter Board √ √ √ √ √
Power Switch
Assembly
√ √ √ √ √
A52 Front Panel
Interface Board / Key
Pad
√ √ √ √ √ √
LCD Assembly √ √ √ √ √
Front Frame √ √ √
Handle Assembly √