Chapter 2 21
Installation
Installing Front Handles/Rack Mounting Flanges
2. Installation
Installing Front Handles/Rack Mounting Flanges
The E5061A/E5062A can be installed on a workbench or in a rack. This section describes
how to install the front handles (Option 1CN) used for moving or transporting the
instrument, and how to install the analyzer in an equipment rack as part of a measurement
system (Option 1CM: without the handles, Option 1CP: with the handles).
Table 2-3 Agilent E5061A/E5062A handles/rack mounting options
Option Name Agilent Part Number
1CN Handle Kit 5063-9229
1CM Rack-mount Kit 5063-9216
1CP Rack-mount and Handle Kit 5188-4430
Table 2-4 Contents of each option
Option Contents Quantity
1CN
Front Handles 2
Screws
6
Trim Strips
2
1CM
Rack-mounting flanges (locking side plate) 2
Screws
6
1CP
Rack-mounting flanges (locking side plate) 2
Front Handles
2
Screws
8
To Next Page
Loading...
