1290 Infinity Quaternary Pump User Manual 279
LAN Configuration
13
Automatic configuration with Bootp
Changing the IP Address of an Instrument Using the Agilent BootP
Service
Agilent BootP Service starts automatically when your PC reboots. To
change Agilent BootP Service settings, you must stop the service, make the
changes, and then restart the service.
Stopping the Agilent BootP Service
1 From the Windows control panel, select Administrative Tools > Services. The
Services screen appears.
Figure 48 Windows Services screen
2 Right- click Agilent BootP Service.
3 Select Stop.
4 Close the Services and Administrative Tools screen.
Editing the IP address and other parameters in EditBootPSettings
1 Select Start > All Programs > Agilent BootP Service and select Edit BootP
Settings. The BootP Settings screen appears.
2 When the BootP Settings screen is first opened, it shows the default
settings from installation.
To Next Page
Loading...
Need help?
General
